24 ways to purify water

 This information is just for your knowledge, it does not really help you to purify your water, but will teach you about various methods used for this purpose.

SEPARATION: HEAT, LIGHT & GRAVITY  SEDIMENTATION gravitationally settles heavy suspended material.

BOILING WATER for 15 to 20 minutes kills 99.9% of all living things and vaporizes most chemicals.  Minerals, metals, solids and the contamination from the cooking container become more concentrated.

DISTILLATION boils and re condenses the water, but many chemicals vaporize and re condense in concentration in the output water.  It is also expensive to boil & cool water.

ULTRAVIOLET LIGHT is a good bactericide, but has no residual kill, and works only in clearly filtered water.   Still in its infancy stage is a new technology involving super white light.

CHEMICALS       CHLORINE is common, cheap, but extremely toxic.  It does not decrease physical or chemical contamination, it does increase cholesterol formations, is a carcinogen, and causes heart disease.

     BROMINE, used in pools and spas, doesn't smell or taste as bad and doesn't kill bacteria very well.

     IODINE is not practical, and is mostly used by campers.

     HYDROGEN PEROXIDE kills bacteria with oxygen, is chemically made and is very toxic.  It is used in emergencies.

     SILVER is an effective bactericide but a cumulative poison which concentrates and doesn't evaporate.

     NONTOXIC ORGANIC ACIDS should be used with caution in large water plants only.

     LIME AND MILD ALKALINE AGENTS should also be used with caution only by large water plants, or only for laundry.

     NEUTRALIZING CHEMICALS react with the unwanted chemicals and produce out gases and a sediment, but levels of need vary.

     COAGULATION-FLOCCULATION adds chemicals which lump together suspended particles for filtration or separation.

     ION EXCHANGE exchanges sodium from salt for calcium or magnesium, using either glauconite (greensand), precipitated synthetic organic resins, or gel zeolite, thus softening the water.  Minerals, metals, chemicals or odors are not affected, and the water is salty to drink.
 
FILTRATION  SLOW SAND of 1 cubic meter passes about 2 liters/min, and does a limited bacteria removal.

PRESSURE SAND of 1 cubic meter passes about 40gpm and must be backwashed daily.

DIATOMACEOUS EARTH removes small suspended particles at high  flow rates, must be daily backwashed and is expensive.

POROUS STONE/CERAMIC filters are small but expensive, and do not effect chemicals, bacteria or odors.

PAPER or CLOTH filters are disposable and filter to one micron, but do not have much capacity.

CHARCOAL:
     -COMPRESSED CHARCOAL/CARBON BLOCK is the best type of charcoal  filter, can remove chemicals and lead, but is easily clogged,  so  should be used with a sediment pre-filter.
     -GRANULAR CHARCOAL is cheaper, but water can flow around the  granules without being treated.
     -POWDERED CHARCOAL is a very fine dust useful for spot cleaning  larger bodies of water, but is messy and can pass through some filters and be consumed.

REVERSE OSMOSIS uses a membrane with microscopic holes that require 4 to 8 times the volume of water processed to wash it in order to remove minerals and salt, but not necessarily chemicals and bacteria.

OXYDATION  AERATION sprays water into the air to raise the oxygen content, to break down odors, and to balance the dissolved gases.  However, it takes space, is expensive, and picks up contaminants from the air.

OZONE is a very good bactericide, using highly charged oxygen molecules to kill microorganisms on contact, and to flocculate iron and manganese for post filtration and backwashing.

ELECTRONIC PURIFICATION and DISSOLVED OXYGEN GENERATION creates super oxygenated water in a dissolved state that lowers the surface tension of the water and effectively treats all three types of contamination: physical, chemical and biological.